HP NonStop G-Series - Manual (Page 153)

NonStop AutoTMF Software Commands
HP NonStop AutoTMF Software User’s Guide—429952-014
6-79
STATS
Note that internally, the default hometerm of the monitor is $ZHOME, as
displayed by the TACL command STATUS $<process-name>, because an
EMS collector cannot be specified as the hometerm of a process when the
process is launched. Functionally however, the home terminal for the monitor
process is the default EMS collector, as shown by the AutoTMF
STATUS
MONITOR command.
STATS
Scans an Enscribe file to determine the record count and distribution of record lengths.
STATS is useful to determine if file records conform to expected lengths.
file-name
is an Enscribe file name.
STATUS MONITOR
Determines the status of the monitor process by sending the monitor inquiries.
*
queries all configured monitor processes.
[\sys.]process-name
specifies the name of the NonStop AutoTMF software monitor process to be
queried. The default is the current monitor for the session.
mapdb
specifies the subvolume of a MapDB. This is an alternative method to specify the
process to be queried.
STATUS TRACE
Request a status of the current active traces from the monitor process. This command
replaces the MONITOR STATUS TRACE command.
trace-index
a number from 0 to 7 that specifies the index number of the trace to report on.
If trace-index is omitted, the status of all active traces is displayed.
STATS file-name;
STATUS MONITOR [ * | [\sys.]process-name | mapdb ];
STATUS TRACE trace-index;