HP Storage Mirroring V5 Software User Manual
Page 102
8
-
6
Options
repset
—Name of the replication set
target_machine
—Name of the target machine, an IP address on the target machine, or a virtual IP
address
MAP EXACT
—Specifies that the replication set data will be sent to the same logical volume on the
target
MAP BASE
—The replication set data will be sent to the locations specified below:
connect repset to target
—If mappings are not specified with the command,
map base
will be used by default. The data will be replicated to
/SrcName/RepsetName/SrcVolName
on the target machine
connect repset to target map base
target_path
—Substitute a complete path, including
the volume, for
target_path
and the data will be replicated to
/target_path/SrcVolName
on
the target machine
connect repset to target map base
source_path
TO
target_path
—Custom location
that specifies each directory on the source and where that data will be copied to on the target
machine
...
—Indicates that the s
ource_path
TO
target_path
option can be used more than once for each
source directory in the replication set
MIRROR
—Automatically initiates a mirror when the connection is established
NOMIRROR
—Does not initiate a mirror when the connection is established
REPLICATE
—Automatically initiates replication when the connection is established
NOREPLICATE
—Does not initiate replication when the connection is established
MONITOR
—Specifies that the target is going to monitor the specified source machine for failover.
The source machine must have already been defined as a monitor machine.
NOMONITOR
—Specifies that the target is not going to monitor the source machine for failover
ORPHANS
—Removes orphan files on the target
NOORPHANS
—Does not remove orphan files on the target
Examples
connect “Customer Data” to jersey map exact
connect marketing to jersey map base /home/username
Notes
The default settings for this command are mirror, replicate, nomonitor, and noorphans.
Options that contain non-alphanumeric characters must be enclosed in quotation marks.
If you are establishing a connection within a NAT environment, you will need to specify the port
of the router after the IP address (separated by a colon).