HP Storage Mirroring V5 Software - Manual (Page 183)

13 - 15
Failback 5200 Info Failback completed for %1. No action required.
5201 Info IP address %1 was removed from
target machine's %2 adapter. No action required.
5202 Error Unable to Failback properly because IP
address %1 was missing a
corresponding SubNet Mask. Contact technical support.
Failover 5100 Info Failover completed for %1. No action required.
5101 Info IP address %1 with subnet mask %2
was added to target machine's %3
adapter. No action required.
5102 Warning %1 has reached a failover condition. A
response from the user is required
before failover can take place. User intervention has been configured.
Open the Failover Control Center and
accept or decline the failover prompt.
5103 Info Started adding drive shares from %1 to
%2. No action required.
5104 Info %1 drive shares were taken over by
%2. No action required.
5105 Info Attempting to run the %1 script. No action required.
5106 Success The %1 script ran successfully. No action required.
5107 Error Error occurred in running %1 script. Verify that the script identified exists
with the proper permissions.
5108 Error The source machine %1 is not
responding to a ping. This occurs when all monitored IP
addresses on the source machine stop
responding to pings. Countdown to
failover will begin at the first
occurrence and will continue until the
source machine responds or until
failover occurs.
5109 Error The public NIC on source machine %1
is not responding to a ping. The failover target did not receive an
answer to its ping of the source
machine. Eventually, a failover will
result. Investigate possible errors
(down server, network error, etc.).
Monitoring 5300 Info The following IP address was added to
target's monitoring list: %1 No action required.
5301 Info The following IP address was removed
from target's monitoring list: %1 No action required.
5302 Info Drive share information for %1 has
been updated on the target machine. No action required.
NSIPHDriver 9000 Error Could not allocate memory for storing
registry path Reboot the server and contact
technical support if this event occurs
again.
9001 Error Thread creation failed Reboot the server and contact
technical support if this event occurs
again.
9002 Error Could not allocate memory for
parameter key Reboot the server and contact
technical support if this event occurs
again.
9003 Error Could not read PlaceHolderCount
from the NSIPH Parameters key Reboot the server and contact
technical support if this event occurs
again.
Category ID Severity Message Required Response