HP NonStop G-Series - Manual (Page 75)

Switch Command Interface (SWCI)
ServerNet Nomadic Disk (Release 2) User’s Guide — 523968-001
6 -5
Switch Module Device Name
4. Start the device
Starting the DEVICE object starts both an ATP6100 line-handler process (WAN I/O
process) and an ATP6100 line. The cable between the switch module and the
SWAN or SWAN 2 concentrator must be connected before you can start the
device. In this example the WAN IOP is named $ZZWAN.#SWITCH1, and the
ATP6100 line is named $SWITCH1.
This example starts the line-handler process and line at the primary node.
->START DEVICE $ZZWAN.#SWITCH1
Switch Module Device Name
When starting SWCI, the device name used for the switch module is not the name of
the DEVICE object, but is the name of the SUBDEVICE object.
The form of the SUBDEVICE name is $ line-name .# subdevice-name.
line-name is created when you add the DEVICE object.
subdevice-name is specified when you add the PROFILE.
In the examples created in Configuring the ATP6100 Line for SWCI Communications
on page 6-3, the names would be:
Node DEVICE Object LINE
Object PROFILE
Object,
NAME
Modifier SUBDEVICE
Object
Primary
node $ZZWAN.#SWITCH1 $SWITCH1 PRI $SWITCH1.#PRI
Backup
node $ZZWAN.#SWITCH2 $SWITCH2 BCK $SWITCH2.#BCK