HP NonStop G-Series - Manual (Page 84)

Switch Command Interface (SWCI)
ServerNet Nomadic Disk (Release 2) User’s Guide — 523968-001
6- 14
SELFTEST Command
SELFTEST Command
The SELFTEST command causes the SCC to perform its power-on self-test (POST)
diagnostics.
Considerations
•
When the SELFTEST command is issued, all switch cards go to the locked state.
•
The key switch on the SCC must be in the REMOTE position, or the POST fails.
You cannot use SELFTEST with the key switch in the LOCAL position.
•
If the POST is successful, SWCI returns the message “SCC self-diagnostics
passed.”
•
If the POST fails, SWCI returns the message “SCC self-diagnostics failed.” Use the
STATUS command to determine the cause of the failure.
Example
SWCI $NDSWA.#TERM> SELFTEST
SCC SELF-DIAGNOSTICS PASSED
SELFTEST