HP NonStop G-Series - Manual (Page 99)

Switch Command Interface (SWCI)
ServerNet Nomadic Disk (Release 2) User’s Guide — 523968-001
6- 29
Command Input/Parsing Error Messages
Cause. A STATUS command contained an invalid scc-attr value.
Effect. The command is not executed. SWCI waits for the next command.
Recovery. Retry the STATUS command with the correct syntax.
Cause. A STATUS SCC command contained an invalid scc-attr value.
Effect. The command is not executed. SWCI waits for the next command.
Recovery. Retry the STATUS SCC command with the correct syntax.
“
Cause. A STATUS ENV command contained an invalid scc-attr value.
Effect. The command is not executed. SWCI waits for the next command.
Recovery. Retry the STATUS ENV command with the correct syntax.
Cause. A LOCK, UNLOCK, or SWITCH command did not contain SC.
Effect. The command is not executed. SWCI waits for the next command.
Recovery. Retry the command with the correct syntax.
“
Cause. A STATUS command did not contain SCC, SC, or ENV to indicate the type of
status requested.
Effect. SWCI returns information about the SCC, all switch cards, and environmental
information.
Recovery. No action is required.
***COMMAND ERROR*** PARTNO, TRACKID, DATE, FWREV, LOCK, or
POSITION expected
***COMMAND ERROR*** PARTNO, TRACKID, DATE, FWREV, or PONTEST
expected
***COMMAND ERROR*** POWER, TEMP, or KEYSWITCH expected
***COMMAND ERROR*** SC expected
***COMMAND ERROR*** SCC, SC, or ENV expected