HP Virtual Connect Flex-10 10Gb Ethernet Module for c-Class BladeSystem - Manual (Page 132)

Virtual Connect networks 132
Use this screen to edit the properties of an existing shared uplink set, add an associated network, or delete
an associated network. This screen has the same fields as the Define Shared Uplink screen. The screen can
be edited only by users with network role permissions, but it is viewable by all authorized users.
The following table describes the fields within the Edit Shared Uplink Set screen.
For shared uplink sets using an FCoE associated network, the following restrictions apply:
• You cannot change the bay number. If you want to use a different bay number, you must delete the
FCoE network first, and then add a new one.
• If a shared uplink set is assigned to a profile, you cannot delete or edit the FCoE network.
Field name Description
Ethernet Shared External Uplink
Set
Uplink Set Name Descriptive name for the shared uplink set. Do not use spaces.
External Uplink Ports
Port Enclosure, bay, and port number
Port Role Displays whether the port is designated as primary or secondary. For shared
uplink sets with an associated FCoE network, this is N/A.
Port Status Shows the link status, link speed, and connectivity of the port. If the port is
unlinked and no connectivity exists, the cause is displayed. For more
information about possible causes, see "Port status conditions (on page
264 )."
ConnectorType The type of connector on the port; for example, RJ-45
Connected To If the individual port is connected to a switch that supports LLDP, the switch
LLDP system name or management IP address and switch port number
appear. A link is provided to obtain more information about the far-end
switch port.