Task 2: start all processors, Task 3: start the zserver process, Task 5: create input files – HP Integrity NonStop H-Series User Manual

Page 205

Advertising
background image

1.

Log on to system through the OSM Low-Level Link.

2.

Select File>Start Terminal Emulator>For Startup TACL and Start Terminal Emulator>For Event
Streams.

3.

On the Low-Level Link toolbar, click Processor Status.

4.

Select a processor to start.

5.

From the Processor Actions list, select SIT Load.

6.

Click Perform Action.

7.

In the Load SIT Using Processor-n dialog box:
a.

Under External SCSI Controller, enter the appropriate Group, Module, and Slot.

b.

Under Options, check that the CIIN Disabled box is selected.

8.

Click Load.

9.

Repeat Steps 4 through 8 for other processors if necessary.

Task 2: Start All Processors

Start all processors that will execute system resources. These might only be processors 0 and 1,
depending on how you distribute system resources.

At the Startup TACL, start the processors:

> RELOAD (n),PRIME

where n is the processor number.

Task 3: Start the ZSERVER Process

At the Startup TACL from the system console:

> ZSERVER/NAME $ZSVR, NOWAIT, PRI 170,TERM $ZHOME, CPU 0/1

Task 4: Configure and Start Required Disk and Tape Drives

Although you could perform a Tape Boot from OSM, the drive is not ready for system use.

1.

Using SCF:

-> ASSUME SENDTO STORAGE
-> ADD DISK $DSMSCM, PRIMARYLOCATION (1,1,3), MIRRORLOCATION (1,1,4)
-> ADD DISK $AUDIT, PRIMARYLOCATION (1,1,7), MIRRORLOCATION (1,1,8)
-> START $DSMSCM
-> START $AUDIT
-> ADD TAPE $TAPE0, LOCATION (1,1,50), DEVICEID 5
-> START $TAPE0
-> EXIT

2.

Using MEDIACOM:

> ALTER TAPEDRIVE *, NLCHECK OFF
> EXIT

If you have backup tapes of your system, you can now restore them.

Task 5: Create Input Files

Run SIT2SCM to create input files for the RESTORE and FUP utilities. The file for RESTORE restores
all files needed for running DSM/SCM and places them in the correct subvolume. The file for FUP
licenses and sets the PROGIDs for the files. Mount the SUT on tape drive $TAPE0.

> RUN $SYSTEM.SYS00.SIT2SCM $TAPE0 $SYSTEM.subvol.CUSTFILE RESTIN FUPIN

•

subvol

is the subvolume that contains the CUSTFILE.

•

RESTIN

is the name of the input file for RESTORE.

•

FUPIN

is the name of the input file for FUP.

Recovering Installed Products Using SIT2SCM 205

Advertising
This manual is related to the following products: