HP 9000 rp5400 Servers - Manual (Page 124)

Removing rp5470 Memory DIMMs
To remove an rp5470 memory DIMM, perform the following steps:
1. Pull up on the extractor levers on each end of the Memory Carrier to unseat the Memory
Carrier from its socket.
2. When the Memory Carrier unseats from the socket, pull it up and away from the System
Board.
3. Loosen the captive screws that secure the DIMM Clip and remove DIMM Clip from the
Memory Carrier.
4. Press down on the extractor levers on each end of the selected memory DIMM to unseat the
DIMM from its socket.
5. When the memory DIMM unseats from the socket, pull it up and away from the Memory
Carrier.
Memory DIMM Replacement
Memory DIMMs reside in slots located on the System Board (up to eight). They are loaded in
DIMM pairs of equal size.
Replacing rp5400 and/or rp5450 Memory DIMMs
To replace a memory DIMM, perform the following steps:
1. Seat the memory DIMM into its socket.
2. Press the extractor levers on each end of the memory DIMM slot inward until the levers
snap into place.
The following graphics show a memory DIMM and a display of DIMM removal/replacement.
124 Removing and Replacing Components