HP 9000 rp5400 Servers - Manual (Page 20)

NOTE: The perforations and the lip of the outside skin should be toward the rear of the
server.
WARNING! Stacking rp54xx servers in deskside enclosures is not supported.
Stacking rp54xx servers in deskside enclosures can damage equipment, may cause injury
to personnel, and may void your warranty or service contract.
6. Install the Front Bezel.
7. Locate the two pull-tabs. One pull-tab is longer than the other. The shorter pull-tab is blank
on both sides. The back of the shorter pull-tab provides a writable surface for Customer use.
8. Locate the plastic bag containing the label sheet (taped to the server).
9. Remove the label containing serial number, base product, processor product, and model
information from the label sheet and apply to the back of the longer pull-tab.
NOTE: Pull-tab and label shown above is for an rp74xx server. rp54xx uses the same style
label and similar pull-tab.
10. Insert the pull-tabs into the front bezel. Install the longer pull-tab in the left side plastic
window in such a way that the rp54xx logo is visible. Install the shorter pull-tab in the right
side plastic window with either surface visible. Refer to the diagram above for pull-tab
locations.
Install Stand-Alone Server in a Cabinet
The following describes how to install the A5556A slide-tray assembly into an approved HP
cabinet in preparation for installing an rp54xx server.
This slide-tray assembly can be installed in an HP E-Series cabinet or other HP cabinets approved
for rp54xx system installation. To install the A5556A slide-tray assembly in an approved HP
equipment cabinet, proceed as follows:
20 Server Unpacking and Installation