HP 9000 rp5400 Servers - Manual (Page 129)

Replacing rp5470 Platform Monitor
Looking into the Top Service Bay from the front, the rp5470 model Platform Monitor is located
on the right side at the front of the server.
To replace a Platform Monitor, perform the following steps:
1. Seat the Platform Monitor into its socket.
2. Lift the extractor levers and press them onto each end of the Platform Monitor until the
levers snap into place.
The following graphics show a Platform Monitor board followed by a display of Platform Monitor
removal/replacement.
PCI I/O Card Removal
The side service bay contains card slots for ten PCI I/O cards (slots 3 through 12) and two Core
I/O cards (slots 1 and 2).
Perform the following tasks prior to removing PCI I/O cards:
• Power down the server.
• Detach all power cords from the server.
To remove a PCI I/O card from the server, perform the following steps:
Individual Component Remove/Replace Instructions 129