HP Console Management Controller - Manual (Page 27)

Installation 2-9
Compaq Confidential – Need to Know Required
Writer: A. J. Scheckelhoff Project: Compaq Console Management Controller User Guide Comments:
Part Number: 218258-002 File Name: c-ch2 Installation.doc Last Saved On: 7/19/01 10:30 PM
Intrusion Sensor
Intrusion Sensor
An intrusion sensor consists of two parts:
■ A magnet
■ An electrical switch
1. The magnet should be installed on the inside of the rack door and the
electrical switch on the rack as shown in the following instructions.
Make sure the magnet and switch align with each other and allow
sufficient clearance for the doors to close.
2. The intrusion sensors should be installed on the front door

of the rack,
as well as the rear door
.
1 2
Figure 2-5. Installing the intrusion sensor in the 9000 series rack