HP Console Management Controller - Manual (Page 86)

5-2 Compaq Console Management Controller User Guide
Compaq Confidential – Need to Know Required
Writer: A. J. Scheckelhoff Project: Compaq Console Management Controller User Guide Comments:
Part Number: 218258-002 File Name: f-ch5 Troubleshooting.doc Last Saved On: 6/20/01 8:48 PM
Troubleshooting During Startup
If problems occur when starting the Compaq CMC, select the appropriate
symptom for possible causes and actions.
Table 5-1
Troubleshooting Guide (CMC Startup)
Description of Fault Symptom Solution
Check the AC power connection. The CMC fails to function after
power up.
Make sure unit is On.
Make sure sensor is connected to correct port on
the rear of the CMC.
Check the cables to the sensors for cable breaks.
Connected sensors are not
recognized by the CMC.
If applicable, check the power supply to the
sensors.
Verify network connection is correctly installed.
Verify the correct IP address is programmed into
the unit.
Alarm signals are only indicated on
the CMC but not at the console
management.
Contact network administrator.
There is no shock alarm, despite
the presence of vibrations. Use software to adjust sensitivity. See Chapter 4.
Verify intrusion magnetic switches are properly
installed. Intrusion alarms do not activate
when door is opened.
Verify sensors connected to the correct port on the
rear of the unit.
Check the sensors for correct installation. Faults are not reported although
sensors are connected.
Verify that sensors are connected to the proper
port on the rear of the unit.
Check the connection to the network. The interface LEDs are not giving
any signals.
Contact network administrator.