HP LaserJet 4100 Multifunction Printer series User Manual
Page 148
146 Appendix D – System administrator guide
EN
10 Close the DIMM access door. Make sure that it locks into
place.
11 Insert the bottom of the cover into the slot and rotate the
cover upward.
12 Slide the cover toward the front of the MFP until the cover
clicks into place. Plug in the power cord, reconnect all
cables, and turn the MFP on.
13 Follow this procedure to verify that the DIMM is installed
correctly:
●
Check that the control panel shows
READY
. If an error
message appears, the DIMM might have been
incorrectly installed. Review the installation if necessary.
See
“Understanding control panel messages” on
for more information.
●
Print a new menu map and configuration page and
compare the new menu map to the map that you printed
out before the DIMM installation. If any values are
different, make the appropriate changes in the affected
menus.
●
Compare the new configuration page with the one that
you printed earlier.
Note
If you installed a new firmware DIMM, the Firmware Datacode
listed in the upper-left block of the page should have been
updated to reflect the DIMM replacement. If any values are
different and cannot be changed using the menus, call for
support.
10
11
12