HP LaserJet 4100 Multifunction Printer series - Manual (Page 86)

84 Chapter 8 – Problem solving EN
8 Remove the media that has jammed.
CAUTION
Do not use a sharp object to clear media from the fuser area.
You might damage the fuser.
9 Replace the fuser, left side first. Be sure to push the fuser
firmly into the product.
10 Lock the fuser in place by rotating the levers to the
horizontal position.
11 Replace the rear output slot, left side first.
12 Plug the power cord into the product.
13 Replace the Tray 2 dust cover or the optional duplexer.
14 Turn the MFP on.
15 If a jam message persists, media remains in the product.
Look for media in another location (see “Jam locations” on
page 78 ).
Note
Because the product has been turned off, you must restart the
copying or printing task.
Clearing jams from the ADF
If originals jam in the ADF, follow this procedure:
1 Raise the ADF cover.
2 Remove any jammed media.
3 Close the ADF and control panel unit. Press each down firmly until it clicks into
place.
4 After removing the stack of originals from the ADF, smooth the jammed page, add it
to the top of the stack, and reinsert the stack.
5 Press S TART to resume sending or copying the document.
8
9
10
11