HP Designjet 10000s Printer series - Manual (Page 117)

24. At the front of the printer, use the black media advance switch to feed the media (1) on the main
scroller enough so that you can install the tension bar in the slack area.
NOTE If there is an obvious difference in the amount of media feed between the main
scroller and sub-scroller, you should try to adjust the sub-scroller back tension to improve
the difference in feed, refer to
Adjust the back tension of the sub-scroller
25. Install the tension bar (2) in the supports (1).
CAUTION Make sure you install the tension bar with the ESD contact ring at the right hand
end of the tension bar (viewed from the front of the printer).
NOTE The tension bar is not used for the media on the sub-scroller.
ENWW Install dual media rolls on separate scrollers 107
How do
I use dual medi
a
rolls?