HP Designjet 10000s Printer series - Manual (Page 28)

CAUTION The printer power switch at the rear of the printer should only be used when the
printer is turned off to move it, connect it to a computer, or to install or maintain printer parts.
Turn off the power on/off switch, wait for at least ten seconds, then turn it on again.
The printer washes the printheads 20 hours after the last printing process and every 3 days. We
recommend that the printer power is always left on.
Turn off the heaters
Turn off the heaters by pressing the On/Off keys on the heater front panel.
Under normal conditions of use, you do not need to turn off the heaters using the heater power switch
(1) on the rear of the printer.
NOTE Use the heater switch at the rear of the printer only when turning the printer off completely
for removal, installation, or servicing.
Replace an ink cartridge
CAUTION Always use genuine HP ink cartridges. These have been designed for high-quality
imaging performance and reliable printer operation. Using non-HP inks may cause poor print
quality, printer malfunction, or printer failure. The hazard characteristics of different solvent inks
can vary widely. HP has not conducted product safety testing for non-HP inks with this printer
and is not responsible for any loss or damage that may result if non-HP inks are used.
HP ink cartridges must be installed before the “Install By” date printed on the cartridge. Use of
the ink cartridge 3 months beyond the “Install By” date may cause deterioration in print quality or
a printer malfunction.
NOTE
If an ink cartridge cannot be inserted, check that the color matches the slot. A mechanical key
prevents an ink cartridge from being inserted into the wrong slot.
Do not shake ink cartridges before inserting into the printer.
18 Chapter 1 Introduction ENWW
Int
rod
uct
ion