HP Designjet 10000s Printer series User Manual
Page 195
Advertising
3.
Carefully slide the support arm (1), as far as it will go, into the mounting hole (2) provided for it in the
chassis. The attachment bracket with the larger hole must be at the top.
4.
Secure the support arm (3) using the two attachment screws (1) and (2) removed previously.
5.
Repeat the previous three steps, to install the support bar on the chassis at the cap end.
ENWW
Use the liner separator bar
185
How
do
I prin
t wit
h
a lin
er
Advertising