HP Virtual Connect Flex-10 10Gb Ethernet Module for c-Class BladeSystem - Manual (Page 39)

Command line 39
Item Description
preferred speed. The default value is "Auto".
PrefSpeed
(required if
PrefSpeedType is
"Custom")
The connection speed for any Ethernet connection attached to this network. Valid
values range from 100Mb to 10Gb in 100Mb increments.
MaxSpeedType
(Optional)
The maximum connection speed for any Ethernet connection attached to this network.
Valid values include "Unrestricted" and "Custom". "Custom" enables the user to
configure the preferred speed. The default value is "Unrestricted".
MaxSpeed
(required if
MaxSpeedType is
"Custom")
The maximum connection speed for any Ethernet connection attached to this network.
Valid values range from 100Mb to 10Gb in 100Mb increments.
Examples
->add network MyNewNetwork
Creates a new network, and then adds it to the domain
->add network MyNewNetwork2 UplinkSet=MyUplinkSet VLanID=145
Creates a new network and uses a shared uplink port set
->add network Network1 Private=Enabled
Configures a private network when adding a new network
->add network Network1 UplinkSet=Uplinkset1 VLANID=100
NativeVLAN=Enabled
Creates a new network with a shared uplinkset and tags it as Native VLAN
->add network Network1 ConnectionMode=Failover
Creates a new network and sets the connection mode as failover
->add network Network1 VLanTunnel=Enabled
Creates a new network and enables VLAN tunneling
->add network Network1 PrefSpeedType=Custom PrefSpeed=4000
MaxSpeedType=Custom MaxSpeed=6000
Creates a new network with a preferred connection speed of 4Gb and maximum
connection speed of 6Gb
Item Description
remove network Remove a network from the domain. To remove a network, it must not be in use by any
server profiles.
Syntax
remove network <NetworkName | *>
Parameter
NetworkName
(required)
The name of an existing network in the domain. A network name of "*" removes all
networks.
Examples
->remove network MyNetwork
Removes a network
->remove network *
Removes all networks
Item Description
set network Modify an existing Ethernet network.
Syntax
set network <NetworkName> [-quiet] [Name=<NewName>]
[State=<Enabled|Disabled>]
[SmartLink=<Enabled|Disabled>][NativeVLAN=<Enabled|Disabled>]
[Private=<Enabled|Disabled>] [VlanId=<New VLanId>]
[ConnectionMode=<Auto|Failover>]
[VLanTunnel=<Enabled|Disabled>] [PrefSpeedType=<Auto|Custom>]
[PrefSpeed=<100Mb–10Gb in 100Mb increments>]