HP Virtual Connect Flex-10 10Gb Ethernet Module for c-Class BladeSystem - Manual (Page 41)

Command line 41
Item Description
->set network Network1 Private=Enabled
Enables a private network
->set network Network1 VlanId=150
Changes the VLAN ID of a network associated with a shared uplink set
->set network Network1 VLanTunnel=Enabled
Enables VLAN tunneling on the network
->set network Network1 PrefSpeedType=Custom PrefSpeed=4000
MaxSpeedType=Custom MaxSpeed=6000
Modifies network to preferred connection speed of 4Gb and maximum connection
speed of 6Gb
Item Description
show network Display all Ethernet networks in the domain.
Syntax
show network [<NetworkName> | *]
Parameter
NetworkName
(optional)
Name of an existing network in the VC domain. "*" displays a detailed view of all the
networks. If not specified, a summary view of the networks is displayed.
Examples
->show network
Displays a summary listing of all networks
->show network *
Displays detailed information for all networks
->show network MyNetwork
Displays detailed information for a specific network
port-monitor
Manage port monitor configuration.
Supported actions: help, add, remove, set, show
Item Description
add port monitor Add a new network analyzer port and other ports to be monitored.
Syntax
add port-monitor [AnalyzerPort=<PortID>]
[Speed=<Auto|10Mb|100Mb|1Gb|10Gb|Disabled>]
[Duplex=<Auto|Half|Full>] [MonitorPort=<PortID>]
[Direction=<ToServer|FromServer|Both>]
Properties
AnalyzerPort
(optional)
The uplink port that is used for monitoring network traffic. Only one port can be
configured as the analyzer port.
After a port has been allocated to port monitoring, it is not available for use in VC
networks and shared uplink sets.
The format of the network analyzer port is
<EnclosureID>:<InterconnectBay>:<PortNumber>.
If the enclosure ID is not specified, the default enclosure is the local enclosure where
the domain resides.
Speed (optional) The port speed for the network analyzer port. Valid values include "Auto",
"10Mb", "100Mb", "1Gb", "10Gb", and "Disabled". The default value is "Auto".
If there is no connector present on the analyzer port, only "Auto" and "Disabled"
can be configured as a possible speed. Speed restrictions apply.