ARCHOS DVr stAtioN - Manual (Page 16)

DVr stAtioN
16
User ManUal - version 1
2 nd test: changing channels on your tuner
After you select “ Yes ” at the end of the 1 st test, the following screen appears. It allows you to correctly set the
parameters so that the ARCHOS can change channels on your tuner (for a scheduled recording).
For the “ Channel ” parameter, select the highest channel that is currently memorized on your tuner.
Select the “ Test channel select ” button. Make sure that your tuner is on. Your ARCHOS device will then
attempt to switch your tuner to the selected channel. After a few seconds, your ARCHOS will ask you if the
device responded correctly:
If this worked, select “ Yes ”.
If this did not work, select “ No, try next option ”. Your device will try again to switch your tuner to the
selected channel, using a different option*. Repeat this operation until it works.
*Here is a description of the different parameters it will use. These parameters can be set manually as well:
“Key Delay”: delay between the emission of each digit of a channel (“ Short ”, “ Normal ”, “ Long ”).
“Key: Enter”: Set to “ On ” if normally, you have to press an “ OK ” button on your turner’s remote control
after you enter the channel number. Example: If you normally press 1, 3, “ OK ” to access channel 13, then
this parameter is set to “ On ”.
“Key: -/--”: Set to “ On ” if normally, you need to press a special key on your tuner’s remote control before
entering a channel with several digit numbers (that is to say a channel greater than 9). This key is often
represented with this symbol: “
-/-- ”.
“Switches on with”: see below.
“Time until video”: see below.
If the ARCHOS did not manage to switch your tuner to the selected channel, you can try using different ON/OFF codes
(see: 1
st Test: turning your tuner off) and do the 2 nd test again.
After you selected “ Yes ” at the end of the 2 nd step, the following screen appears. You will have to set these
two parameters:
1.
2.


-
-
-
-
-
3.