Alcatel Carrier Internetworking Solutions Omni Switch/Router - Manual (Page 1020)

Backup Services Commands
Page 34-10
Modifying a Frame Relay PVC Backup Service
To modify a backup service for a frame relay PVC:
1. First, enter the bsmodify command, followed by the index of backup service, followed by
<return> , as shown in the example below:
/Interface/backup % bsm b2 <return>
A screen similar to that shown below will display:
1) Description : Backup 1
2) Admin Status { (E)nabled, (D)isabled } : Enabled
Primary Type : Frame Relay PVC
Slot : 3
Port : 3
DLCI : 32
Backup Type : PPP Peer
Peer ID : 1
5) Startup Timer Value {Time in Seconds after
System Startup to wait
for Primary to come up
before activating
Backup }
: 300
6) Activate Timer Value (Time in Seconds after
Primary Failure to
activate Backup }
: 10
7) Restore Timer Value {Time in Seconds after
Primary restoral to
disable Backup }
: 10
(save/quit/cancel)
:
The command functions in a manner similar to the create command, except the parame-
ters that define the backup service may not be changed. These parameters are the:
• index
• primary type
• primary type subparameter
• backup type, and
• backup type subparameters.
Only the Description and Timer fields may be modified.
2. Once you are satisfied with the values, enter the save command, followed by <return> at
the prompt, as shown below:
: save <return>
A screen similar to that shown below will display:
Backup Service Index 2 modified.
/Interface/backup %