HP Virtual Connect FlexFabric 10Gb24-port Module for c-Class BladeSystem - Manual (Page 106)

Command line 106
Item Description
"SNMPv1".
Severity Trap severities to send to the destination. Values are "Normal", "Unknown", "Info",
"Warning", "Minor", "Major", "Critical", "All", and "None". Multiple severities
can be specified, separated by commas. The default severity is "None".
DomainCategories The VC domain trap categories to send to the destination. Values are "Legacy",
"DomainStatus", "NetworkStatus", "FabricStatus", "ProfileStatus", "ServerStatus",
"EnetStatus", FcStatus", "All", and "None".
Multiple categories can be specified, separated by commas.
EnetCategories The VC Ethernet trap categories to send to the destination. Values are "PortStatus",
"PortThreshold", "Other", "All", and "None". Multiple categories can be specified,
separated by commas.
FcCategories The VC Fibre Channel trap categories to send to the destination. Values are
"PortStatus", "Other", "All", and "None". Multiple categories can be specified,
separated by commas.
Examples
->set snmp-trap MyTrap1 Community=public
Sets the trap community
->set snmp-trap MyTrap1 Severity=All FcCategories=None
EnetCategories=None
Sets all trap severities and sets the Fibre Channel and Ethernet categories to none
->set snmp-trap MyTrap
Address=fe80:0000:0000:0000:0202:b3ff:fe1e:8329
Sets a trap using an IPv6 address
Item Description
->show snmp-trap Displays the SNMP traps that have been configured.
Syntax
show snmp-trap [Name|*]
Parameter
Name (optional) The name of the trap configuration to be displayed. If no trap name is specified, or
"*" is entered, all configured traps are displayed.
Examples
->show snmp-trap MyTrap1
Displays the SNMP trap configuration for a single trap
->show snmp-trap *
Displays all configured SNMP traps
Item Description
->test snmp-trap Generates an SNMP test trap and sends it to all configured destinations.
Traps participating in the test must be configured, at a minimum, with the following
attributes:
DomainCategories=DomainStatus
Severity=Info
Syntax
test snmp-trap
Example
->test snmp-trap
Generates an SNMP test trap and sends it to the configured destinations