HP Virtual Connect FlexFabric 10Gb24-port Module for c-Class BladeSystem - Manual (Page 61)

Command line 61
Item Description
->remove log-target 3
Removes log-target index number 3
Item Description
set log-target Modify the properties of an existing remote log destination.
Syntax
set log-target <ID> [Destination=<IPAddress|DNS>]
[Severity=<Critical|Error|Warning|Info>]
[Transport=<TCP|UDP>] [Port=<1-65535>]
[Security=<None|STunnel>] [Format=<RFC3164|ISO8601>]
[State=<Enabled|Disabled>]
Parameter
ID (required) The index of the remote log destination to modify
Properties
Destination
(optional)
The IP address or the DNS name of the previously configured remote log
destination
Severity (optional) Severity of the log messages that should be sent to the specified destination.
Values include "Critical", "Error", "Warning", and "Info". The default value is
"Info".
Transport (optional) The transport protocol to be used for sending the log messages to the destination.
Values include "TCP" and "UDP". The default value is "UDP".
Port (optional) The port to be used on the destination to send the log messages. Values include
1 to 65536. The default value is 514.
Security (optional) Secure transmission of the log messages. Values include "None" and "STunnel".
The Default value is "None", and no encryption is used during transmission.
The "STunnel" option can be used only if the transport protocol is set to "TCP".
Format (optional) The timestamp format for the log messages. Values include "RFC3164" (Nov 26
13:15:55) and "ISO8601" (1997-07-16T19:20:30+01:00). The default value
is "RFC3164".
State (optional) Enables or disables the remote log destination. Values include "Enabled" and
"Disabled". The default value is "Disabled".
Examples
->set log-target 1 Severity=Error Transport=TCP
Security=STunnel
Modifies log-target index number 1
->set log-target 1 Destination=192.168.3.1
Modifies log-target at index 1 to use a new IP address
->set log-target 1
Destination=2001:0db8:85a3:0000:0000:8a2e:0370:7334
Modifies log-target at index 1 to use a new IPv6 address
Item Description
show log-target Display the remote log destination settings.
Syntax
show log-target [<ID|*>]
Parameter
ID (optional) The index of the remote log destination to view. Use "*" to display detailed
information for all remote log destinations.
Example
->show log-target
Displays all log destination settings