HP ProLiant BL620c G7 Server-Blade - Manual (Page 47)

Hardware options installation 47
6. Install the DIMM.
7. Do one of the following:
o Install the right DIMM baffle.
o Install the left DIMM baffle.
8. Install the access panel (on page 16 ).
9. Install the server blade (" Installing a server blade " on page 28 ).
10. Power up the server blade (on page 14 ).
Hot-plug SAS or SATA hard drive option
IMPORTANT: To avoid improper operation, install only hot-plug hard drives in this server blade.
IMPORTANT: The following configurations are not supported:
• Installation of both SAS and SATA hard drives in a single RAID volume
• Installation of SSD and rotating media hard drives in a single RAID volume
A Smart Array P410i controller supports either two hot-plug SAS or two hot-plug SATA hard drives. Hard
drive activity is indicated by the hard drive LEDs on the hard drives.
RAID 0 and 1 are supported and do not require a cache module to be installed.
CAUTION: To prevent improper cooling and thermal damage, do not operate the server blade
or the enclosure unless all hard drive and device bays are populated with either a component or
a blank.
To install the component: