HP LaserJet 2300 Printer series - Manual (Page 92)

90 Chapter 4 Problem solving ENWW
LOAD TRAY [XX]
[TYPE] [SIZE]
alternates with
To use another
tray press
or
For help press
or
To continue press
A job is sent that requires a specific
type and size that is not available in
the tray that is indicated. Perform one of these steps:

Load the requested media into
the indicated tray and press
( S ELECT button).

Press to use a type and
size that are available in
another tray.
MANUALLY FEED
[TYPE] [SIZE]
alternates with
To use another
tray press
or
For help press
or
To continue press
The printer is waiting for media to
be loaded in tray 1 for manual feed. Perform one of these steps:

Load the requested media into
the tray 1 and press
( S ELECT button).

Press ( S ELECT button) to
use a type and size that are
available in another tray.
No job to cancel The C ANCEL J OB button was
pressed, but there is no active job or
buffered data to cancel.
The message is displayed for
approximately 2 seconds before the
printer returns to the ready state.
No action necessary.
ORDER CARTRIDGE
LESS THAN [XXXX] PAGES This message appears when the
CARTRIDGE LOW setting in the
System Setup submenu is set to
CONTINUE and the cartridge has
only 10 percent of its toner
remaining (see
“ CARTRIDGE LOW ” on
page 155 ).
Make sure that you have a new
cartridge ready (see
“Ordering
parts, accessories, and supplies” on
page 116
).
Paused
alternates with
To return to ready
press RESUME key
The printer is paused but continues
to receive data until the memory is
full. The printer is not experiencing
an error. Press P AUSE /R ESUME .
SIZE MISMATCH
TRAY [XX]= [SIZE]
alternates with
Ready
For help press
The tray indicated is loaded with a
different size of paper than the size
configured for the tray. Load the tray with the size
configured for the tray.
Make sure that the guides are
positioned correctly in the tray, and
then make sure that the switch in
the tray is set correctly to Custom or
Standard.
TRAY [ XX] EMPTY
[TYPE] [SIZE]
alternates with
Ready
For menus press
The tray is out of media. Load paper in the empty tray to
clear the message.
If you do not load the specified tray,
the printer will continue printing from
the next available tray with the
same paper size and type, and the
message will continue to appear.
Message Description Recommended action