HP StorageWorks 2.32 Edge Switch - Manual (Page 199)

Edge Switch Element Manager user guide 199
Zoning by port number
is ignored in Open
Fabric Mode.
While in Open Fabric mode,
zones configured using port
numbers are enforced through
WWNs.
Informational message only—no action
is required.
Zoning by port number
is not supported in
Open Fabric Mode.
You cannot specify an item for
zoning by port number if HAFM
is in Open Fabric mode.
Either define zones by the WWN of
the device or change to
Homogeneous Fabric mode in the
Configure Operation Mode dialog
box of the Element Manager.
Zoning name already
exists.
Duplicate zone names are not
allowed in the zoning library.
Modify (to make it unique) or delete
the duplicate zone name.
Table 9 HAFM messages (continued)
Message Description Action