Related topics – HP XP Racks User Manual
Page 82
Description
SSB2 code
The pair task was rejected because the volume you specified as the S-VOL is a command device.
2383
The pair task was rejected because the volume you specified as the S-VOL is a reserved volume for
Auto LUN.
2386
The pair was not created because the volume you specified as the P-VOL is the volume for Auto LUN.
2387
The pair was not registered in the CG because the number of the pairs assigned to the CG has
exceeded the defined maximum number of pairs.
2394
The pair task was rejected because you are reverse resynchronizing the pair sharing the specified
volume as the P-VOL.
2395
The pair task was rejected because you are reverse resynchronizing the L1 pair sharing the specified
P-VOL as the root volume.
2396
The pair task was rejected because you are reverse resynchronizing the L2 pair sharing the specified
P-VOL or S-VOL as the node volume.
2397
The reverse resynchronization was rejected because the pair is not split (“PSUS” status) or suspended
(“PSUE” status).
2398
The reverse resynchronization was rejected because some of the pairs sharing the specified volume
as the P-VOL are not in split (“PSUS” status) or suspended (“PSUE” status).
2399
The pair was not created because you set the Protect attribute for the volume you specified as the
S-VOL using BCM.
239E
The reverse resynchronization was rejected because the volume you specified is the P-VOL for XRC.
23A8
The pair was not restored because the volume you specified is the P-VOL for CC.
23A9
The pair task was rejected because the volume you specified as the S-VOL is the P-VOL for XRC.
23AA
The pair task was rejected because the volume you specified as the S-VOL is the P-VOL for CC.
23AB
The pair was not registered in the CG because IBM PPRC has reserved the specified CG number.
23AF
The pair was not created because the volume you specified as the S-VOL could not be used as the
S-VOL because of Volume Security settings.
23BB
The pair was not deleted because the P-VOL and S-VOL are in the process of being Quick Split.
23EF
The pair was not created because the CTG identifier you specified is not supported.
23F1
You cannot run the command because the system did not authenticate your user information.
9100
The pair task was rejected because the specified volume did not exist.
B911
The pair was not created because the specified S-VOL does not exist.
B912
The pair task was rejected because the mirror ID is invalid.
B913
Related topics
•
“Troubleshooting consistency group pair-split failures” (page 82)
.
Troubleshooting consistency group pair-split failures
If a consistency group (CG) pair-split fails, note the following:
•
The pairs in the CG are suspended (“PSUE” status).
•
If the host server is down or has failed, you can assign a pair to a CG that is not associated
to another BC pair. If you are using RAID Manager to run commands under such a condition,
do not run the following command with CG pair-split:
Paircreate
In this case, do the following:
82
Troubleshooting Business Copy