HP MPX200 Multifunction Router - Manual (Page 33)

Keywords
Specifies the Fibre Channel port number, where the first port is 1. -fc_port
Specifies the FC target WWNN.
If the -fc_port keyword is used and this keyword is not, the router uses the default
WWNN for the presented Fibre Channel target. -wwnn=
Specifies the FC target WWPN. -wwpn=
If the -fc_port keyword is used and this keyword is not, the router uses the default
WWPN for the presented Fibre Channel target.
Example
c:\> rcli map global_iscsi_target iSCSI -fc_port=1
Global Target successfully mapped to FC port 1
map target
The map target command maps an iSCSI or Fibre Channel target to an iSCSI or Fibre Channel
port.
Syntax
map target
NOTE: You must specify either the -fc_target or -is_target keyword, but not both.
You must specify either the -fc_port or -ge_port keyword, but not both.
Keywords
Specifies the Fibre Channel port number, where the first port is 1. -fc_port=
Specifies the name of the Fibre Channel target to map to the iSCSI or Fibre Channel
port. -fc_target=
Specifies the GbE port number, where the first port is 1. -ge_port=
This keyword is combined with the -ge_port keyword to specify the iSCSI target
name. -iscsi_name=
If the -ge_port keyword is used and -iscsi_name is not specified, the router
uses a default name for the presented iSCSI target.
Specifies the name of the iSCSI target to map to the iSCSI or Fibre Channel port. -is_target=
Specifies the virtual port group index Values are: -vpgindex=
• virtual port group index starting at 1
•
none
This keyword is combined with the -fc_port keyword to specify the WWNN of
the FC target. -wwnn=
If the -fc_port keyword is used and -wwnn is not specified, the router uses the
default WWNN for the presented Fibre Channel target.
This keyword is combined with the -fc_port keyword to specify the WWPN of
the FC target. -wwpn=
If the -fc_port keyword is used and -wwpn is not specified, the router uses the
default WWPN name for the presented Fibre Channel target.
map target 33