HP P6000 Continuous Access Software - Manual (Page 194)

Comments
•
This template cannot be used with some older versions of controller software.
•
HP recommends that you perform restores of host volumes using the GUI.
Example
This template was generated to copy (restore) one storage volume. No other template options were
selected.
Task Line
// Synchronize storage volume(s) to other storage volume(s) 1
// 2
// Assign some variables that will be used in this job. 3
$source_storvol_unc1 = SetVariable(%source_storvol_unc1%) 4
$dest_storvol_unc1 = SetVariable(%dest_storvol_unc1%) 5
// 6
// Validate that resources are as expected. 7
ValidateStorageVolume ($dest_storvol_unc1) 8
// 9
// Begin flushing the cache on the storage volume(s). 10
DO { 11
SetStorageVolumeWriteCacheMode ($source_storvol_unc1, WRITE_CACHE_DISABLED, NOWAIT) 12
// 13
// Wait for the cache flush to complete. 14
WaitForStorageVolumeWriteCacheFlush ($source_storvol_unc1) 15
// 16
// Convert the destination storage volume(s) into container(s). 17
$CT1 = ConvertStorageVolumeIntoContainer ($dest_storvol_unc1) 18
// 19
SnapcloneStorageVolumeToContainer ($source_storvol_unc1, $CT1, NOWAIT) 20
// 21
} ALWAYS { 22
// Restore the writeback cache on the storage volume(s). 23
SetStorageVolumeWriteCacheMode ($source_storvol_unc1, WRITE_CACHE_ENABLED, NOWAIT) onerror
continue 24
// 25
} 26
// 27
Exit (SUCCESS 28
// 29
194 Jobs