HP P6000 Continuous Access Software - Manual (Page 212)

Example
This template was generated to replicate one host volume and mount it on two different enabled
hosts. No other template options were selected.
Task Line
// Replicate host volume(s), mount to a host, then to a different host. 1
// 2
// Assign some variables that will be used in this job. 3
$source_hostvol_unc1 = SetVariable(%source_hostvol_unc1%) 4
$source_host = SetVariable(%source_host%) 5
$mount_host1 = SetVariable(%mount_host1%) 6
$launch_host_name = SetVariable(%launch_host_name%) 7
$mount_host2 = SetVariable(%mount_host2%) 8
// 9
// Validate that resources are as expected. 10
ValidateHost ($launch_host_name) 11
ValidateHost ($mount_host2) 12
ValidateHost ($mount_host1) 13
ValidateHostVolume ($source_hostvol_unc1) 14
ValidateSnapshotHostVolume ($source_hostvol_unc1 15
// 16
$Rep1 = SnapshotHostVolume ($source_hostvol_unc1, FULLY_ALLOCATED, SAME, WAIT) onerror pauseat E1: 17
// 18
// Mount the replicated volume(s) on a host. 19
PresentStorageVolumes ($Rep1, $mount_host1) onerror pauseat E2: 20
DiscoverDiskDevices ($mount_host1, $Rep1) onerror continue 21
$HV1 = CreateHostVolumeFromDiskDevices ($source_hostvol_unc1, $Rep1, $mount_host1) onerror pauseat
E2: 22
$MP1 = MountHostVolume ($HV1, %mount_point1%) onerror pauseat E5: 23
// 24
// Launch a backup process on a host. 25
Launch ($launch_host_name, %command_line%, "", WAIT, "0") onerror pauseat E6: 26
// 27
// Unmount the volume(s). 28
E6: UnmountHostVolume ($MP1) onerror pauseat E6: 29
E5: DeleteHostVolume ($HV1) onerror pauseat E5: 30
// 31
// 32
PresentStorageVolumes ($Rep1, $mount_host2) onerror pauseat E2: 33
212 Jobs