HP P6000 Continuous Access Software - Manual (Page 45)

Refreshing resources (global)
Update replication manager database entries by manually performing a global discovery and
refresh of resources.
Considerations
•
Manual refresh
IMPORTANT: HP recommends that you manually refresh storage resources after using another
interface that changes the properties of storage systems, DR groups, or virtual disks. Refreshing
resources, especially storage resources, can take a significant amount of time and place heavy
demands on the management server and storage systems.
•
Information in the content pane is not automatically updated after a refresh.
Procedure
1. On the toolbar, click the refresh icon.
The Global Refresh Monitor window appears. See Global refresh monitor .
1. Global refresh icon on toolbar
2. You can do one of the following:
•
Click Close to close the window and continue working.
•
View the refresh progress bars.
•
Click Refresh to restart the refresh.
3. Update the content pane. See Refreshing display panes .
Refreshing individual resources
Update replication manager database entries by manually performing a discovery and refresh of
individual resources.
Considerations
•
Individual resource refresh is only available for DR groups, enabled hosts, and virtual disks.
•
You can use the GUI or CLUI.
Procedures
•
DR groups. See Low-level refreshing DR groups .
•
Enabled hosts. See Low-level refreshing enabled hosts .
•
Virtual disks. See Low-level refreshing virtual disks .
Selection of multiple resources
When performing an action from the GUI, HP recommends selecting only a few resources at one
time. Selecting a large number of resources at once can cause slow response times.
Working with resources 45