HP ProLiant ML350 G4 Server - Manual (Page 61)

Hardware Options Installation 61
6. Configure the device by setting the SCSI ID. The SCSI ID on each device in
the media bays must be manually set to a unique value. Refer to the
documentation provided with the device for instructions on setting the SCSI
ID.
7. Remove all terminating jumpers from third-party SCSI devices.
8. Install the guide screws ("Identifying Guide Screws" on page 58 ), if
applicable.
9. Slide the drive into the bay until it clicks into place.
10. Connect the data and power cables to the back of the device.