HP Integrity NonStop J-Series - Manual (Page 28)

Operating the Tape Drive
M8609A Tabletop Tape Drive Installation and User’s Guide— 546013-002
3- 10
Ultrium Cartridges
Perform these steps before applying the label into the recessed area on the cartridge:
1. Make sure the cartridge has been at room temperature for at least 24 hours.
2. Clean the surface where the labels will be placed using a cleaning solution made
for this purpose.
3. Locate the type of label that you require.
4. Hold the cartridge so that the write protect switch is toward you.
5. Attach the label to the cartridge as shown in Figure 3-6 .
Figure 3-6. Ultrium Cartridge Label