HP ProLiant SL210t Gen8 Server - Manual (Page 36)

Hardware options installation 36
a. Position the heatsink on the processor backplate.
b. Tighten one pair of diagonally opposite screws halfway, and then tighten the other pair of screws.
c. Finish the installation by completely tightening the screws in the same sequence.
14. In a 1U node configuration:
a. Install the 1U air baffle (on page 28 ).
b. Install the 1U cable guard (on page 19 ).
15. In a 2U node configuration:
a. Install the 2U air baffle (on page 26 ).
b. Connect the Mini-SAS cable (on page 24 ).
c. Install the 2U adapter board bracket (on page 23 ).
d. Install the PCI riser cage (on page 21 ).
16. Install the node into the chassis (" Installing a node into the chassis " on page 30 ).
17. Connect all peripheral cables to the node.
18. Power up the node (" Power up the nodes " on page 17 ).