HP Color LaserJet CP3520 Printer Series - Manual (Page 162)

3. Locate the thumb screws on the formatter board in the rear of the product.
4. Unscrew the thumb screws and then pull the formatter board from the product. Place the formatter
board on a clean, flat, grounded surface.
5. To replace a DIMM that is currently installed, spread the latches apart on each side of the DIMM
slot, lift the DIMM up at an angle, and pull it out.
XO XO XO XO XO XO
XOXOXOXOXOXO
XOXO XOXO XO
XOX OXO XOXO
XOXO XOXO XO
XOXO XO XOXO
XOXOXOXOXOXO
XOXO XO XO XO
XOXOXO
XOXOXO
XOXOXO
XOXOXO
XOXOXO
XOXOXO
XOXOXO XOXOXO XOXOXO
XO XO XO
XO XO XO
XOXOXOXO XO XO XO
XO XO XO
XOXOXO
6. Remove the new DIMM from the antistatic package. Locate the alignment notch on the bottom
edge of the DIMM.
150 Chapter 10 Manage and maintain the product ENWW