HP Officejet 150 Mobile All-in-One Printer - L511a - Manual (Page 70)

Check the printer software settings
Print speed is slower when Best or Maximum dpi is selected as the print quality. To
increase the print speed, select different print settings in the print driver. For more
information, see Print.
Check for radio interference
If the printer is connected using Bluetooth wireless and is printing slowly, then the radio
signal might be weak. For more information, see Set up the printer for Bluetooth
communication.
Check the Bluetooth wireless connection
Printing larger files using a Bluetooth wireless connection can sometimes cause the
print job to fail. Try printing a smaller file. For more information, see Problems setting
up Bluetooth communication.
Blank or partial page printed
Clean the ink cartridge
Complete the ink cartridge cleaning procedure. For more information, see To clean ink
cartridges automatically.
Check the battery charge level
If the printer is using battery power, make sure the battery is charged and functioning
properly. If the battery charge level is critically low, the printer might not print the entire
page before ejecting the page. Plug in the power cord to begin charging the battery.
For more information about using the battery, see Install and use the battery.
Check the media settings
•
Make sure you select the correct print quality settings in the print driver for the
media loaded in the input tray.
• Make sure the page settings in the print driver match the page size of media
loaded in the input tray.
Check the Bluetooth connection
Printing larger files using a Bluetooth connection can sometimes cause the print job to
fail. Try printing a smaller file. For more information, see Problems setting up Bluetooth
communication.
More than one page feeds through the printer
For more information on paper-feed problems, see Solve paper-feed problems.
There is a blank page in the file
Check the file to make sure there is no blank page.
Chapter 6
66 Solve a problem