HP LaserJet Pro 400 color Printer M451 series - Manual (Page 47)

Install software for Mac computers on a wired network
Configure the IP address
1. Connect the network cable to the product and to the network.
2. Wait for 60 seconds before continuing. During this time, the network recognizes the product and
assigns an IP address or host name for the product.
Install the software
1. Install the software from the CD. Click the product icon, and follow the onscreen instructions.
2. Print a page from any program to make sure that the software is correctly installed.
Install software for Mac computers on a wireless network
Before installing the product software, make sure the product is not connected to the network using a
network cable. Make sure your Mac computer is connected to the same wireless network to which
you plan to connect the product.
Use one of the following procedures to connect the product to the wireless network.
● Connect the product to a wireless network using WPS by using the control panel menus
● Connect the product to a wireless network using a USB cable
If your router supports Wi-Fi Protected Setup (WPS), use that method to add the product to your
network. This is the simplest way to set up the product on a wireless network.
NOTE: Apple AirPort wireless routers do not support WPS button setup.
If your wireless router does not support Wi-Fi Protected Setup (WPS), obtain the wireless router
network settings from your system administrator, or complete the following tasks:
● Obtain the wireless network name or service set identifier (SSID).
● Determine the security password or encryption key for the wireless network.
ENWW Software for Mac 29