HP LaserJet Pro 400 color Printer M451 series - Manual (Page 60)

Printer sharing disclaimer
HP does not support peer-to-peer networking, as the feature is a function of Microsoft operating
systems and not of the HP printer drivers. Go to Microsoft at
www.microsoft.com .
Use HP Smart Install to connect to a computer, a wired
network, or a wireless network
NOTE: This installation type is supported for Windows only.
The software installation files are in the product memory. The HP Smart Install program uses a USB
cable to transfer the installation files from the product to your computer. This installer supports USB
connections, wired networks, and wireless networks. It installs all files you need to print. To use the
HP Smart Install program, follow one of these procedures, depending on your connection type.
NOTE: If you prefer not to use the HP Smart Install program, you can insert the product CD to
install the software.
HP Smart Install for Windows direct connections (USB)
1. Connect an A-to-B type USB cable to the computer and the product. The HP Smart Install
program might take a few minutes to start.
2. Follow the onscreen instructions.
NOTE: The HP Smart Install program might take a few minutes to start. If the installation program
does not start automatically, the AutoPlay feature might be disabled on the computer. In Windows
Explorer, browse the computer, and then double-click the HP Smart Install driver and run the
installation program.
NOTE: If the HP Smart Install program fails, disconnect the USB cable, turn the product off and
then on again, and then insert the product CD into your computer. Follow the onscreen instructions.
Connect the cable only when the software prompts you.
HP Smart Install for Windows wired networks
1. Connect a network cable to the product and a network port. Allow a few minutes for an IP
address to be assigned.
2. On the product control panel, the product IP address alternates with the Ready message on the
display. Make note of the IP address.
3. At the computer, open a Web browser and type the IP address in the URL address bar to open
the HP Embedded Web Server. Click the HP Smart Install tab and follow the onscreen
instructions.
NOTE: If the HP Smart Install program fails, insert the product CD into your computer. Follow the
onscreen instructions.
42 Chapter 5 Connect the product with Windows ENWW