HP Unified Extensible Firmware Interface - Manual (Page 60)

Table 12 Sysconfig Settings (continued)
Possible Values Description Setting Name
nl UtcP430 [UTC+04:30, Kabul]
nl UtcP5 [UTC+05:00, Ekaterinburg,
Islamabad, Karachi, Tashkent]
nl UtcP530[UTC+05:30, Chennai, Kolkata,
Mumbai, New Delhi]
nl UtcP545 [UTC+05:45, Kathmandu]
nl UtcP6 [UTC+06:00, Almaty,
Novosibirsk, Astana, Dhaka]
nl UtcP630 [UTC+06:30, Rangoon]
nl UtcP7 [UTC+07:00, Bangkok, Hanio,
Jakarta, Krasnoyarsk]
nl UtcP8 [UTC+08:00, Taipei, Beijing,
Chongqing, Hong Kong, Urumqi]
nl UtcP9 [UTC+09:00, Osaka, Sapporo,
Tokyo, Seoul, Yakutsk]
nl UtcP930 [UTC+09:30, Adelaide,
Darwin]
nl UtcP10 [UTC+10:00, Canberra,
Melbourne, Sydney, Guam, Hobart,
Vladivostok]
nl UtcP11 [UTC+11:00, Magadan,
Solomon Is., New Caledonia]
nl UtcP12 [UTC+12:00, Auckland,
Wellington, Fiji, Kamchatka, Marshall
Is.]
nl UtcP13 [UTC+13:00, Nuku'alofa]
nl UtcP14 [UTC+14:00, Line Islands]
nl Unspecified [Unspecified Time Zone]
time
Displays or sets the current time for the system.
Syntax
time [hh:mm [:ss]] [-tz tz] [-d dl]
Options
hh Sets a new hour value (0–23)
mm Sets a new minute value (0–59)
ss Sets a new second value (0–59). If not specified, zero is used.
-tztz Sets a time zone adjustment, in minutes, offset from GMT. Valid values can be between
-1440 and 1440 or 2047. If not present or set to 2047, time is interpreted as local time.
-d dl Sets a daylight savings time value. Valid values are:
•
0 —Time is not affected by daylight savings time.
•
1 —Time is affected by daylight savings time but has not been adjusted.
•
3 —Time is affected by daylight savings time and has been adjusted.
If no value follows –d, then the current daylight savings time is displayed.
Description
This command displays or sets the current time for the system. If no parameters are used, it shows
the current time. If valid hours, minutes, and seconds are provided, then the system's time is updated.
60 UEFI Shell command reference