Paper is not picked up from the input tray – HP Photosmart C5580 All-in-One Printer User Manual
Page 150
Paper is not picked up from the input tray
Try the following solutions to resolve the issue. Solutions are listed in order, with the most
likely solution first. If the first solution does not solve the problem, continue trying the
remaining solutions until the issue is resolved.
•
Solution 1: Make sure the paper is loaded correctly
•
Solution 2: Check the print settings
•
•
Solution 4: Contact HP support for service
Solution 1: Make sure the paper is loaded correctly
Solution: Make sure that the paper is loaded correctly in the input tray.
For more information, see:
Cause: The paper was not loaded correctly.
If this did not solve the issue, try the next solution.
Solution 2: Check the print settings
Solution: Check the print settings.
•
Check the paper type setting to make sure it matches the type of paper loaded in
the input tray.
•
Check the quality setting. Use a higher quality setting to increase the amount of
ink used for printing.
For more information, see:
•
“Set the paper type for printing” on page 53
•
“Change the print speed or quality” on page 54
•
“Print using Maximum dpi” on page 60
•
“Change copy speed or quality” on page 88
Cause: The paper type or print quality settings were set incorrectly.
If this did not solve the issue, try the next solution.
Solution 3: Clean the rollers
Solution: Clean the rollers.
Make sure you have the following materials available:
•
A lint-free cloth, or any soft material that will not come apart or leave fibers.
•
Distilled, filtered, or bottled water (tap water might contain contaminants that can
damage the print cartridges).
Print quality troubleshooting
147
Trou
bles
ho
ot
ing