HP EML E-series Tape Libraries - Manual (Page 22)

Figure 17 Ports on the switch for the internal network
1. 10/100Base-TX RJ-45 ports
Operator control panel
The OCP displays library status information and enables you to access the library menus with a
touch screen. Use these menus to view and change the library settings, move tape cartridges,
obtain status information, or run diagnostic tests. Functions provided by the OCP are:
•
Robotic and tape drive firmware revision reporting
•
Library configuration
•
Library and tape drive serial number reporting
•
Critical component status report
•
Critical component failure notification
•
Ability to move tapes to and from any location
•
Ability to configure barcode label length and justification reporting to the front panel and to
the host
•
Access to error information
•
Adjust screen contrast
Figure 18 Location of the OCP
Numbering
All of the tape cartridge slots and tape drives in a library are numbered with a coordinate system.
You might see these numbers in your application software or in error or diagnostic messages. Error
22 Library overview