HP EML E-series Tape Libraries - Manual (Page 37)

Table 3 OCP components (continued)
Options to view or select Tab
Reboot Library
Media Operations >
•
Move Tape
• Clean Drive
Run Admin Tests >
•
Operator Control Panel >
Align Touch Screen
◦
◦
Panel Colors
◦
Panel Pixel Test
◦
Panel Firmware Version
◦
Turn Backlight Off
•
Inventory Library
• Run Demo
•
Run Self Test
• Slot Test
•
Drive Load/Unload Test
• Force Rewind Unload Test
•
Recalibrate Library
HP Support Info Support
Service Menu >
Contact Information
Display Library Time
Status screen
The Status screen provides access to the current state of every library component.
Power supplies, load ports, tape drives, and interface controllers are all numbered from top to
bottom in the rack. However, power supplies are numbered by slot, so if a slot is not filled with a
power supply, the slot still receives a number. For example, the top power supply slot in the rack
is power supply 1. The power supply slot under that is power supply number 2. If a power supply
is on the same level horizontally (like those in the card cage expansion module), the one to the
right (facing the back of the rack) has the next highest number. If a component is removed, the
numbering does not change until you reboot the library. After a reboot, the library rediscovers all
components and reassigns numbers from top to bottom.
Using the OCP 37