HP EML E-series Tape Libraries - Manual (Page 41)

Table 6 Operations screen functions (continued)
Description Function
Performs the following tasks: Media Operations
•
Move Tape Select a Source and Element Type (where you want to
move a tape from) and a Destination and Element Type (where you
want to move a tape to).
Element types consist of a tape drive, load port (I/O), or slot location.
Numbers can be entered from the keypad. The up/down arrows cycle
you through full (source) or empty (destination) locations.
After choosing a source and destination, select Move.
•
Clean Drive Select the cleaning media and the drive to be cleaned.
Performs the following tests: Run Admin Tests
•
Operator Control Panel
Align Touch Screen Touch and release the screen near the rectangle
in the center. As you approach the rectangle at some point, it
◦
changes color. The color change takes place when the border of
the rectangle is touched. This is where the touch pad and visual
screen should be aligned. Use the Up/Down/Left/Right buttons to
align the screen.
There is no visual effect when using the adjustment buttons. Use the
touch screen again to make sure that the adjustment is how you
want it. Select the Save tab to make the adjustments permanent.
◦
Panel Colors —Displays the range of colors available to the OCP.
◦
Panel Pixel Test—Tests for bad screen pixels. Select the Test button
to turn all pixels black. Touch the screen to turn all pixels white.
Touch the screen again to end the test.
◦
Panel Firmware Version—Displays the version of the OCP firmware.
◦
Turn Backlight Off—When pressed, turns the OCP backlight off.
• Inventory Library—Performs an inventory of all the tape cartridges in
a library. Unlabeled tapes are shown as FULL if the library has been
configured to detect unlabeled tapes.
•
Run Demo—Performs tape swaps between slots and load ports. Set
the number of loops to be performed (must be at least one). When the
demo completes, the tape cartridges are back in their original
configuration.
•
Run Self Test—Initializes the mechanics and performs tests to make
sure the library is functioning correctly. Tests include verifying the status
of all components; tape exchanges between storage slots, load port
slots, and tape drives; and corner-to-corner slot exchanges. When the
self test completes, the tape cartridges are back in their original
locations.
•
Slot Test—Performs a repeated move of a tape from one slot to another.
Select the source slot, the destination slot, and the loop count, and
then select Start Test.
•
Drive Load/Unload Test—Moves media into and out of each tape
drive for a specified number of loops.
• Force Rewind Unload Test—Clears the prevent media removal bit for
a tape drive and unloads the tape cartridge to its original slot or to
the first empty slot. Interrupts the tape drive operation that is currently
running, if any. Use the Up and Down arrows to select the tape drive
that you want to force rewind unload.
• Recalibrate Library—Recalibrates all the targets in the library.
Using the OCP 41