HP e-CommerceXML Accelerator sa7150 - Manual (Page 127)

C H A P T E R 6 Remote Telnet Sessions
117
Enable remote Telnet sessions:
HP SA7150> set telnet enable
Configure the network route:
HP SA7150> set route
Enter Default Route (’none’ to delete)
[10.1.1.1] :
Verify the route configuration (optional):
HP SA7150> show route
Default Route : 10.1.1.1
Delete a route configuration (optional):
HP SA7150> set route none
NOTE: To ensure that
this remote management
configuration persists
across a device shutdown
and startup, run the
config save command. Remote Telnet management is now enabled and configured on the
SA7150. Now you can access the CLI from a remote Telnet session.
Remote
Console,
Telnet With remote Telnet enabled on the SA7150, use the following
procedure to access it’s CLI:
Unix-prompt> telnet 10.1.1.1
Trying 10.1.1.1...
Connected to 10.1.1.1.
Escape character is ’^]’.
.
.
.
Serial 0:a0:a5:11:4:2e
password:<password>