HP StorageWorks 2500 Disk System - Manual (Page 26)

Locate the following components, which were ordered separately:
• Disk drives
• FC cables
• FC cable labels
Installing the DS2500
This section describes the procedure to install the DS2500:
1. Installing the snap-in rails , page 26
2. Reducing the enclosure weight , page 29
3. Installing the DS2500 in the rack , page 31
4. Connecting the cables , page 33
5. Setting the enclosure ID (En) , page 34
6. Setting the enclosure loop ID (Li) , page 35
7. Verifying the installation , page 36
NOTE:
HP recommends that you install the heaviest components low in the rack to ensure rack stability.
Installing the snap-in rails
1
2
CXO8193A
3
1. Left rack rail
2. Right rack rail
3. Pins for round-hole rack conversion (8)
Figure 10 Contents of snap-in rail-mounting kit
You can identify the left and right rack rails by the markings (L) and (R) stamped into the sheet metal.
NOTE:
The rail kit contains adapter brackets that are used when mounting some devices in the rails; however
these brackets are not used when mounting a DS2500.
26 Installation