HP StorageWorks 2500 Disk System - Manual (Page 59)

WARNING!
The blower motor does not stop immediately when the blower power is removed. Keep your fingers
away from the blower blades until the motor stops.
To remove a blower:
While pushing in on the two mounting tabs (
Figure 32 -1), pull the blower ( Figure 32 -2) away from
the power supply.
1. Mounting tabs (2)
2. Blower
Figure 32 Removing a blower
Replacing a blower
CAUTION:
Pressing on the center section of the blower can damage the blades or the housing. Only press on
the outer edge of the blower.
To replace a blower:
1. Align the blower guide post ( Figure 33 -2) with the mounting hole next to the power supply
connector ( Figure 33 -1).
2. Slide the blower onto the blower base ( Figure 33 -4) until the mounting tabs ( Figure 33 -3)
snap into place.
3. Verify that the blower starts and the power supply/blower assembly LED is on.
2500 Disk System user guide 59