HP StorageWorks 2500 Disk System - Manual (Page 62)

2. Pull the disk drive part way out of the enclosure ( Figure 34 -3) and wait for the media to stop
spinning.
3. Remove the disk drive from the enclosure ( Figure 34 -3).
Figure 34 Removing a disk drive
Replacing a disk drive
To replace a disk drive:
1. Push the ejector button on the disk drive, and pull the release lever down to the full open position.
2. Align the drive with the bay, and slide the drive into the enclosure as far as it will go ( Figure
35 -1).
3. Close the release lever until it engages the ejector button, and the disk drive plugs into the
backplane ( Figure 35 -2).
4. Press in firmly on the disk drive to ensure that it is seated properly.
5. Verify that the drive activity indicator remains on for at least 10 seconds.
Figure 35 Replacing a disk drive
62 Customer self repair