HP XP Racks - Manual (Page 62)

For XP1024/XP128 Disk Array, RAID Manager supports four types of port names for host groups:
•
Specifying the port name without a host group:
CL1-A CL1-An where n unit ID for multiple RAID
•
Specifying the port without a host group:
CL1-A-g where g : host group CL1-An-g where n-g : host group=g on CL1-A in unit ID=n
The following ports can only be specified for XP12000 Disk Array/XP10000 Disk Array and
XP24000/XP20000 Disk Array:
Option Option Option Basic Port
rn qn pn nn mn ln kn jn hn gn fn en dn cn bn an CL5
rn qn pn nn mn ln kn jn hn gn fn en dn cn bn an CL6
rn qn pn nn mn ln kn jn hn gn fn en dn cn bn an CL7
rn qn pn nn mn ln kn jn hn gn fn en dn cn bn an CL8
rn qn pn nn mn ln kn jn hn gn fn en dn cn bn an CL9
rn qn pn nn mn ln kn jn hn gn fn en dn cn bn an CLA
rn qn pn nn mn ln kn jn hn gn fn en dn cn bn an CLB
rn qn pn nn mn ln kn jn hn gn fn en dn cn bn an CLC
rn qn pn nn mn ln kn jn hn gn fn en dn cn bn an CLD
rn qn pn nn mn ln kn jn hn gn fn en dn cn bn an CLE
rn qn pn nn mn ln kn jn hn gn fn en dn cn bn an CLF
rn qn pn nn mn ln kn jn hn gn fn en dn cn bn an CLG
•
Target ID: Defines the SCSI/fibre target ID number of the physical volume on the specified
port. See
“Fibre/FCoE-to-SCSI address conversion ” (page 52) for further information about
fibre address conversion.
•
LU#: Defines the SCSI/fibre logical unit number (LU#) of the physical volume on the specified
target ID and port.
For fibre channel, if the TID and LU# displayed on the system are different from the TID on the fibre
address conversion table, then use the TID and LU# indicated by the raidscan command in the
RAID Manager configuration file.
•
MU# for Business Copy/Business Copy/Snapshot: Defines the mirror unit number (0 - 2) if
using redundant mirror for the identical LU on Business Copy. If this number is omitted it is
assumed to be zero (0). The cascaded mirroring of the S-VOL is expressed as virtual volumes
using the mirror descriptors (MU#1-2) in the configuration definition file. The MU#0 of a mirror
descriptor is used for connection of the S-VOL. The mirror descriptor (MU#0-2) can be used
on Business Copy and Business Copy/Snapshot. MU#3-63 can only be used on Business
Copy/Snapshot.
S-VOL P-VOL SMPL Feature
MU#1-63 MU#0 MU#3-63 MU#0-2 MU#3-63 MU#0-2
Invalid valid Invalid valid Invalid valid Business Copy
Valid valid valid valid valid valid Snapshot
62 Sample configuration definition files