HP XP Racks - Manual (Page 66)

(5) HORCM_LDEV
The HORCM_LDEV parameter is used for specifying stable LDEV# and Serial# as the physical
volumes corresponding to the paired logical volume names. Each group name is unique and
typically has a name fitting its use (for example, database data, Redo log file, UNIX file). The
group and paired logical volume names described in this item must also be known to the remote
server.
•
dev_group: This parameter is the same as HORCM_DEV parameter.
•
dev_name: This parameter is the same as HORCM_DEV parameter.
•
MU#: This parameter is the same as HORCM_DEV parameter.
•
Serial#: This parameter is used to describe the Serial number of RAID box. For XP7 Storage,
set the number to which 300,000 is added to the serial number.
•
CU:LDEV(LDEV#): This parameter is used to describe the LDEV number in the RAID storage
system and supports three types of format as LDEV#.
#dev_group dev_name Serial# CU:LDEV(LDEV#) MU#
oradb dev1 30095 02:40 0
oradb dev2 30095 02:41 0
◦ Specifying "CU:LDEV" in hex used by SVP or Web console Example for LDEV# 260 01:
04
◦ Specifying "LDEV" in decimal used by the inqraid command of RAID Manager Example
for LDEV# 260 260
◦ Specifying "LDEV" in hex used by the inqraid command of RAID Manager Example for
LDEV# 260 0x104
(6) HORCM_LDEVG
The HORCM_LDEVG parameter defines the device group information that the RAID Manager
instance reads. For details about device group, refer to the manual HP XP7 RAID Manager User
Guide.
The following values are defined.
•
Copy group: specifies a name of copy group. This is equivalent to the dev_group of
HORCM_DEV and HORCM_LDEV parameters.
RAID Manager operates by using the information defined here.
•
ldev_group: Specifies a name of device group that the RAID Manager instance reads.
•
Serial#: Specifies the storage system serial number. For XP7 Storage, set the number to which
300,000 is added to the serial number.
HORCM_LDEVG
#Copy_Group ldev_group Serial#
ora grp1 64034
(7) HORCM_INSTP
This parameter is used to specify "pathID" for Continuous Access Synchronous link as well as
"HORCM_INST". PathID must be specified from 1 to 255. If you do not specify the PathID, the
behavior is the same as when 'HORCM_INST' is used.
HORCM_INSTP
dev_group ip_address service pathID
VG01 HSTA horcm 1
VG02 HSTA horcm 2
Note: The path ID can be specified at Continuous Access Synchronous/Continuous Access
Journal/Continuous Access Journal Z. However, the path ID cannot be specified at Cnt Ac-J/Cnt
Ac-J Z when connecting XP12000 Disk Array/XP10000 Disk Array or XP24000/XP20000 Disk
66 Sample configuration definition files